Example of fish eyes. Photo courtesy of Chemcraft.
Here are some common finishing problems and how to solve them.
Problem: Bénard cells: Cell pattern in the finish; color and surface irregularities. Solutions: Add dispersant; add silicone additive to reduce surface tension; increase application viscosity; lower application thickness; add thixotrope or thickener.
Problem: Blooming: Hazy deposit on film; oily or wax-like substance on surface; reduced gloss; mottled or non-uniform surfaces. Solutions: Adjust catalyst level – over–catalyzation; do not use stearated materials such as lacquers and certain polyesters under acid catalyzed coatings; check formula for incompatibility; check substrate for contamination.
Problem: Blushing: Whitening of surface; lowering of gloss. Solutions: Reduce humidity; use richer thinner; check the water level in equipment; warm lacquer to room temperature; increase the temperature of application area; slow dry time; dry waterborne stains or sealers.
Problem: Cold check; cracks in finish. Solutions: Decrease dry film build; ensure minimum room temperature during cure; use only freshly catalyzed material; ensure correct catalyzation; ensure profiles are sanded to reduce sharp angles.
Problem: Cratering: Depressions in finish with raised edges and material at center. Solutions: Clean substrate and equipment before application; filter material; check/clean air system and ventilation control; addition of silicone flow agent.
Problem: Crawling: Formation of beads, islands, craters or pinholes; poor wetting of substrate. Solutions: Clean substrate before application; ensure sanding before application; addition of silicone flow agent.
Problem: Fish eyes: Depressions in the finish with raised edges and uniform material at the center; undispersed droplets in paint. Solutions: Remove the source of contamination or incompatibility; clean substrate and equipment before application; clean air system and ventilation control; addition of silicone flow agent.
Problem: Floating: Mottled, blotchy or streaked appearance; separation and uneven distribution of pigment; the result of Bénard cell formation. Solutions: Increase application viscosity; lower application thickness; add thixotrope or thickener; add dispersant; add silicone additive to reduce surface tension.
Problem: Orange peel: Surface bumpiness or waviness; poor leveling. Solutions: Check and/or lower viscosity; apply correct or thicker film build; reduce dry spray or overspray; increase atomizing air; reduce fluid pressure; check correct air cap; use retarder solvent or rich thinner; eliminate excessive air movement; add silicone flow agent; apply an even stroke with a spray gun at the correct distance.
Problem: Sagging: Gravity-driven flow on vertical surfaces. Solutions: Speed up the solvent balance; control or reduce the application of material; increase application viscosity; correct spray application, avoid overlap, use correct gun angle, speed, gun movement; apply several thinner coats; reduce drafts and application in direct sunlight; increase temperature of application area; reduce application nozzle size; reduce fluid pressure.
Problem: Tearing: Large cracks in the waterborne finish; uneven drying of the surface before the body of the paint film; poor through cure in waterborne materials. Solutions: Decrease surface heat to finish; increase substrate temperature.
Problem: Telegraphing: Structural or surface features revealed in the finish; show-through of fingerprints, water spots or sanding marks. Solutions: Addition of silicone flow agent; increase the viscosity of coating; addition of thixotrope; faster solvent balance.
Source: Chemcraft/AkzoNobel. For information, call 336-841-5111 or visit Chemcraft.com. More troubleshooting tips and videos in the Tools tab online at Chemcraft.
Have something to say? Share your thoughts with us in the comments below.
Sign Up for Woodworking Network Newsletters
Get the latest headlines delivered to you daily Subscribe